(801) 374-6214
To order by fax:
(801) 374-0634
To order by email.
or for questions:
Click here
Site
produced and administered by
International Library Service.
Copyright 1998-2000.
All rights reserved.
Direct comments to:
International Library Service
P.O. Box 735
Provo, Utah 84603
ASME
Measurement Standards
(Standards for dimensional
metrology and calibration of instruments.)
B89.1.6-2002
Measurement of Plain Internal Diameters for use as a Master Rings or Ring
Guages
$43.00
This Standard is intended to establish uniform practices for the measurement of master rings or ring gages using horizontal methods. The standard includes requirements for geometric qualities of master rings or ring gages, the important characteristics of the comparison equipment, environmental conditions, and the means to assure that measurements are made with an acceptable level of accuracy. This Standard does not include measurement methods for rings below 1 mm (0.040 in.). The measurement method on these very small rings should be agreed upon prior to manufacture or calibration between the manufacturer/laboratory and customer.
Order #: L04802
ISBN #: 0791827615
Published: 2002
Product Type: Print-Book
No. of pages: 32
STANDARDS QUICK FIND
A13, A17, A18.18.1, A18.1, A90, A112, A120, AG, B1, B4, B5, B16, B17, B18 CU, B18 M, B20, B27.6, B27.7, B27.8M, B29, B30, B31, B32, B36, B40, B46, B47, B73, B89, B94, B107, BPE, BTH, CSD, HPS, HST, MFC, MH1, N278, N509, N510, NOG, NQA, NUM, OM, PALD, PCC, PTC, PVHO, QAI, QEI, QFO, QHO, QME, QMO, QRO, RA-S, RTP, SI, STS,TDP, Y14, Y32,
The latest
codes,
standards,
and related
publications
available from
ASME.
Click
here
for the
Boiler & Pressure Vessel
Code